PhantoMount X2 F450 2 Axis Gimbal
(Unassembled)




Product Description
The
PhantoMount X2 2-Axis Gimbal from Rc-Drones frame and mounting plate is
made entirely of 1.5mm carbon fiber. Designed to work on many platforms
this gimbal utilizes two HiTec 5245MG Digital Ball Bearing servos
directly mounted to both the pitch and roll axis of the camera. This
reduces overall weight, fewer moving parts and greatly simplifies the
design of the gimbal. Purchase the carbon fiber F450/550 Flamewheel Legs
and raise your F450 3.25" off the ground allowing 1.5" of clearance
between the bottom of this gimbal and ground.
Utilizing the Gimbal Stabilization built into the
DJI Naza or Wookong flight controller you can directly power and control
the gimbal. No additional expensive stabilization controller is needed.
Installation onto your DJI F450 is easy too. Orient
your bottom plate so that the bottom plate "wings" are to the front and
back (see pics, reconfiguration of your F450 airframe and settings may
be required). Attach the legs to each arm, mount the gimbal to the
bottom of your DJI F450 with the included hardware and connect to your
flight controller. Set up and tune the gimbal in the DJI Assistant
Software and film where you fly!
We recommend that you power your PhantoMount X2
gimbal servos through a 6v BEC harness. This will provide smoother
reaction and cleaner videos.
**HERO 3 GO PRO CAMERA AND DJI F450 NOT INCLUDED**
Included:
- Unassembled PhantoMount X2 F450 2 Axis gimbal
Required:
Manufactured by Phoenix Flight Gear"Created and manufactured by pilots for pilots"