PhantoMount X2 F450 2 Axis Gimbal
(Assembled)






Product Description
The PhantoMount X2 F450
gimbal frame and mounting plate is made of 1.5mm carbon fiber. Designed
to work on many platforms this gimbal utilizes two HiTec 5245MG Digital
Ball Bearing servos directly mounted to both the pitch and roll axis of
the camera. This reduces overall weight, moving parts and greatly
simplifies the design of the gimbal. Purchase the carbon fiber F450/550
Flamewheel Legs and raise your F450 3.25" off the ground allowing 1.5"
of clearance between the bottom of this gimbal and ground.
Utilizing the Gimbal
Stabilization built into the DJI Naza or Wookong flight controller you
can directly power and control the gimbal. No additional expensive
stabilization controller is needed.
The X2 F450 gimbal will arrive fully
assembled and tested. Installation onto your DJI F450 is easy too.
Attach legs to your Flame Wheel and, mount the gimbal to the bottom of
your DJI F450 with the included hardware and connect to your flight
controller. Set up and tune the gimbal in the DJI Assistant Software and
film where you fly!
We recommend that you power your PhantoMount
X2 gimbal servos through a 6v BEC harness. This will provide smoother
reaction and cleaner videos.
The X2 version of the PhantoMount gimbals is
intended for aerial photography with the GoPro camera out of its case.
For FPV flight or if you want to have your camera in its protective case
then the PhantoMounts X2 Wide gimbal is more for you.
**HERO 3 GO PRO CAMERA AND DJI F450 NOT INCLUDED**
Included:
- Assembled PhantoMount X2 F450 2 Axis gimbal
Required:
Manufactured by Phoenix Flight Gear"Created and manufactured by pilots for pilots"