PhantoMount X2 Wide F450 2 Axis Gimbal
(Assembled)



The PhantoMount X2
Wide F450 gimbal frame and mounting plate is made of 1.5mm carbon fiber.
Designed to work on many platforms this gimbal utilizes two HiTec
5245MG Digital Ball Bearing servos directly mounted to both the pitch
and roll axis of the camera. This reduces overall weight, moving parts
and greatly simplifies the design of the gimbal. Purchase the carbon
fiber F450/550 Flamewheel Legs to raise your F450 3.25" off the ground
allowing 1.5" of clearance between the bottom of this gimbal and ground.
Utilizing the Gimbal
Stabilization built into the DJI Naza or Wookong flight controller you
can directly power and control the gimbal. No additional expensive
stabilization controller is needed.
The X2 F450 gimbal will
arrive fully assembled and tested. Installation onto your DJI F450 is
easy too. Attach legs to your Flame Wheel and, mount the gimbal to the
bottom of your DJI F450 with the included hardware and connect to your
flight controller. Set up and tune the gimbal in the DJI Assistant
Software and film where you fly!
We recommend that you power
your PhantoMount X2 gimbal servos through a 6v BEC harness. This will
provide smoother reaction and cleaner videos.
The X2 Wide version of the
PhantoMount gimbals is intended for flight with your GoPro out of case
for FPV, in its protective case (no FPV) or, out of case no FPV.
**HERO 3 GO PRO CAMERA AND DJI F450 NOT INCLUDED**
Recommended:
- BEC Harness to power your servos.
Required:
Legs to raise your Flame Wheel
Manufactured by Phoenix Flight Gear"Created and manufactured by pilots for pilots"