PhantoMount X2 F550 2 Axis Gimbal
(Unassembled)





The PhantoMount X2 F550
Gimbal from Rc-Drones frame and mounting plate is made entirely of 1.5mm
carbon fiber. Designed to work on many platforms this gimbal utilizes
two HiTec 5245MG Digital Ball Bearing servos (not included) directly
mounted to both the pitch and roll axis of the camera. This reduces
overall weight, moving parts and greatly simplifies the design of the
gimbal. Purchase the carbon fiber F450/550 Flamewheel Legs and raise
your F550 3.25" off the ground allowing 1.5" of clearance between the
bottom of this gimbal and ground.
Utilizing the Gimbal Stabilization built into the
DJI Naza or Wookong flight controller you can directly power and control
the gimbal. No additional expensive stabilization controller is needed.
Installation onto your DJI F550 is easy too. Attach
the legs to the forward and rear two arms, mount the gimbal to the
bottom of your DJI F550 with the included hardware and connect to your
flight controller. Set up and tune the gimbal in the DJI Assistant
Software and film where you fly!
We recommend that you power your PhantoMount X2
gimbal servos through a 6v BEC harness. This will provide smoother
reaction and cleaner videos.
The X2 version of the
PhantoMount gimbals is intended for aerial photography with the GoPro
camera out of its case. For FPV flight or if you want to have your
camera in its protective case then the PhantoMounts X2 Wide gimbal is
more for you.
**HERO 3 GO PRO CAMERA AND DJI F550 NOT INCLUDED**
Included:
- Unassembled PhantoMount X2 F550 2 Axis gimbal.
Required:
Manufactured by Phoenix Flight Gear"Created and manufactured by pilots for pilots"