PhantoMount X2 F550 2 Axis Wide Gimbal
(Unassembled)



The PhantoMount X2 F550
gimbal frame and mounting plate is made of 1.5mm carbon fiber. Designed
to work on many platforms this gimbal utilizes two HiTec 5245MG Digital
Ball Bearing servos (sold separately) directly mounted to both the pitch
and roll axis of the camera. This reduces overall weight, moving parts
and greatly simplifies the design of the gimbal. Purchase the carbon
fiber F450/550 Flamewheel Legs to raise your F450 3.25" off the ground
allowing 1.5" of clearance between the bottom of this gimbal and ground.
Utilizing the Gimbal
Stabilization built into the DJI Naza or Wookong flight controller you
can directly power and control the gimbal. No additional expensive
stabilization controller is needed.
Installation onto your
DJI F550 is easy too. Attach legs to your Flame Wheel and, mount the
gimbal to the bottom of your DJI F550 with the included hardware and
connect to your flight controller. Set up and tune the gimbal in the DJI
Assistant Software and film where you fly!
We recommend that you
power your PhantoMount X2 gimbal servos through a 6v BEC harness. This
will provide smoother reaction and cleaner videos.
The X2 Wide version of
the PhantoMount gimbals is intended for flight with your GoPro out of
case for FPV, in its protective case (no FPV) or, out of case no FPV.
**HERO 3 GO PRO CAMERA AND DJI F550 NOT INCLUDED**
Required:
Manufactured by Phoenix Flight Gear"Created and manufactured by pilots for pilots"