Use
this LED kit to light up the arms on our new PFG indestructible
Polycarbonate Frame or make a Lightsaber straw mod for your stock Xtreme
or any of our Xtreme Carbon Fiber frames.
**Electronics and Xtreme components sold separately**
Sample Pics only showing how LED's look in dark
Our
pre-wired LEDs are nothing but quality. The 12v 5mm pure green/red led puts
out a nice color that is sure the illuminate your product or project.
Our 5mm pre-wired leds have built in resistors so that they will work
with the voltage that they are rated for. There is no need for you to
add any additional resistors. The only thing you need to do is add power
/ ground and they will illuminate. It doesn't get much easier than
that.
The 5mm pre-wired leds come with a built in resistor,
all connections are heat shrinked in order to protect them and there is
sufficient wire lead on all of them. LED will run on 7.4v-15v.
We
recommend that you don't continuously run them at 15 volts, but they
will take spikes as high as that without any issues at all.
Additional Information
| Size | 5mm Pre-Wired Round Top |
|---|
| Color | Pure Red/Pure Green
|
|---|
| Luminosity/Brightness | 18,000-20,000 mcd |
|---|
| Forward Voltage | 7.4v-15v (volts) (15v Not Recommended Continuous) |
|---|
| Wire Length | Approximately 15cm (6 inches) |
|---|
| Resistor Built In | Yes |
|---|
| Additional Resistors Required | No |
|---|
| Shrink Wrapped Connections | Yes |
|---|
| Current | 20mA |
|---|
| Wavelength | 515-525nm |
|---|
| Viewing Angle | 20-30 Degrees |
|---|
| Mount Style | Custom |
|---|
| Lens Color | Clear |
|---|
| LED Brightness Class | Super/Ultra/Extreme |
|---|
| Operating Voltage | 10v-15v (volts) (15v Not Recommended Continuous)
|
|---|
Please note:
