Light up your new
ZMR250/Blackout Or any frame with 1.25" front standoff hole spacing with
this Polycarbonate Front/Rear Bumper LED Frame Guard.Great
for night flying. Also protects the front/rear frame edge as it extends
2mm past the edge of the front/rear of the frame to keep the frame edge
from getting damaged.
Installation is
easy. Mount at the bottom of the frame using the 2 screws included with
this kit. The screws go through the poly bumper and then into the frame
and screw into the standoffs.
We include 1 Red and 1 Green LED so
light up the LED's before installation and decide what color you want
for front and back. Solder to your PDB or any 7.4v-15v power source.
You
can also add a plug and power off your battery balance tap. Tuck the
LED into the LED opening and use clear tape and/or the included fishing
line to hold LED in place. You can also put a white or Silver backing
between the polycarbonate and the frame arm for better light reflection.
LED Additional Information:Size 5mm Pre-Wired Round Top
Color Pure Green/Pure Red
Luminosity/Brightness 18,000-20,000 mcd
Forward Voltage 7.4v-15v (volts) (15v Not Recommended Continuous)
Wire Length Approximately 15cm (6 inches)
Resistor Built In Yes
Additional Resistors Required No
Shrink Wrapped Connections Yes
Current 20mA
Wavelength 515-525nm
Viewing Angle 20-30 Degrees
Mount Style Custom
Lens Color Clear
LED Brightness Class Super/Ultra/Extreme
Operating Voltage 10v-15v (volts) (15v Not Recommended Continuous)
Included:(2) Polycarbonate Front/Rear Bumper LED Frame Guards
(1) Phoenix Flight Gear 5mm Green LED
(1) Phoenix Flight Gear 5mm Red LED
(4) M3 x 14mm Button Head Screws
Fishing Line
Weight: (2) Polycarbonate Bumper Guards-7.5g
Manufactured by Phoenix Flight Gear
"Created and manufactured by pilots for pilots"