Homeá>áMulti-Rotor Spare Partsá>áBLADE Parts & Accessories
Phoenix Flight Gear Polycarbonate Frame Guard LED Set For RotorX Raiju/Atom Frames

Phoenix Flight Gear Polycarbonate Frame Guard LED Set For RotorX Raiju/Atom Frames

Your Price:
In Stock Now Shipping
Free Shipping
Email a friend Email a friend
Phoenix Flight Gear Polycarbonate Frame Guard LED Set

for RotorX Raiju/Atom Frames

**Photo below shows exactly what is included**

**Poly Nose Bumper, CF Atom Frame, and motors
DO NOT COME WITH this kit**

**Poly Nose Bumper, CF Atom Frame, and motors
DO NOT COME WITH this kit**

Light up your new RotorX Atom or Raiju frame with this Polycarbonate LED set.

Great for night flying.  Also protects the frame arm edges as this kit extends 1mm past the edge of the arms to keep the edge of the arms from getting damaged. Check out our LED front bumper set for full frontal protection and better visibility. Installation is easy. Mount at the bottom of the frame arm using the included motor screws. Solder to your PDB or any 7.4v-15v power source. You can also add a plug and power off your battery balance tap. Tuck the LED into the LED opening and use clear tape and/or the included fishing line to hold LED in place. You can also put a white or Silver backing between the polycarbonate and the frame arm for better light refection.

Our pre-wired LEDs are nothing but quality. The 12v 5mm pure red/green led puts out a nice color that is sure the illuminate your product or project. Our 5mm pre-wired leds have built in resistors so that they will work with the voltage that they are rated for. There is no need for you to add any additional resistors. The only thing you need to do is add power / ground and they will illuminate. It doesn't get much easier than that.
The 5mm pre-wired leds come with a built in resistor, all connections are heat shrinked in order to protect them and there is sufficient wire lead on all of them.
LED will run on 7.4v-15v.

We recommend that you don't continuously run them at 15 volts, but they will take spikes as high as that without any issues at all.

LED Additional Information:

Size3mm Pre-Wired Round Top
ColorPure Green / Pure Red
Luminosity/Brightness18,000-20,000 mcd
Forward Voltage7.4v-15v (volts) (15v Not Recommended Continuous)
Wire LengthApproximately 15cm (6 inches)
Resistor Built InYes
Additional Resistors RequiredNo
Shrink Wrapped ConnectionsYes
Viewing Angle20-30 Degrees
Mount StyleCustom
Lens ColorClear
LED Brightness ClassSuper/Ultra/Extreme
Operating Voltage10v-15v (volts) (15v Not Recommended Continuous)

We check all LED's before shipping to verify they work.

I am sorry but we cannot offer a warranty on LED's.

(4) Phoenix Flight Gear Polycarbonate LED Pods
(2) Phoenix Flight Gear 3mm Red LED's
(2) Phoenix Flight Gear 3mm Green LED's
(16) M2 x 10mm Button Head Screws 
Fishing Line


Pods weigh 5.5g for all (four)

Manufactured by Phoenix Flight Gear
"Created and manufactured by pilots for pilots"
Browse Similar Items