ARF kit:
We set out to design a transportable
spyder frame and knew that not just transportability had to be taken
into account. Reliability and ease of operation were key aspects we also
had to integrate with our design. After the 625mm Spyder Quad frame
proved to meet our demands we started looking for the right electronics
that would provide reliable efficient lift and power. We chose motors
manufactured by Avroto for us here at Phoenix Flight Gear, the PFG
Edition M2814P-11s 770kv is specifically manufactured to our
specifications. To feed those 4 motors power the highly reliable Maytech
30A OPTO ESC's flashed with Simon-K multirotor firmware will provide
efficient, quiet and reliable power. To simplify the assembly the motor
to ESC connections are made with 3.5mm bullet connectors and color coded
wires. Distribution of power is all taken care of with all of the ESC's
pre-soldered to the power distribution board by VOLTair. Two
JST connectors are also pre-soldered to the distribution board to
provide power to electronic accessories and your flight controller.APC's
10x5.5 composite propellers will provide all the lift required to get
your drone flying high in the sky. Phoenix Flight Gear, created and
manufactured by pilots for pilots.



 |
 |
All our Phoenix Flight Gear frames are 3K twill weave carbon fiber. We DO NOT USE low quality fiberglass composite sandwiched between 2 THIN LAYERS of carbon fiber! Frame:
This Spyder
Quad frame was designed to be highly transportable with all four arms
able to swing back to fold. The frame plates are CNC cut from 1.5mm
carbon fiber and are designed to contain all of your electronics
internally. Light weight powder coated aluminum arms with 2mm CF vented
motor plates keep your motors secure and cool keeping your drone in the
air with heavy payloads. When the propellers are removed the whole frame
can fold and fit into a hard side case making travel to and from flight
locations simple.
Keeping all of
the electronics internally mounted makes the frame build neat and
clean. The frame was designed around the electronics, inside the frame
there are mounting locations for your power distribution, 4 ESC's and,
flight controllers. Venting holes help keep the ESC's cool and improves
the airflow through the interior of the frame as well. Containing the
flight electronics internally provides a massive area on the top or
bottom to mount accessories like, gimbals, FPV, downlinks or anything
else you can think of. We have also provided two mounting locations for
the DJI Zenmuse H3-2D. One centers the gimbal on the frame and the other
keeping the lens in the center of the craft. The goal is to keep your
build clean and functional keeping ease of use a key design aspect.
The included
landing gear allows 135mm clearance below your frame. If you need more
clearance below your quad to mount larger gimbals or equipment then you
can equip the frame with the optional CarbonGear 200mm Carbon Fiber
Landing Gear. The taller landing gear combined with the CarbonGear 7mm
Rail Mount will allow you to mount an AV130, rail mount brushless
gimbal, rail mount accessory / battery plate or any other accessory that
has a 80mm width, 7mm rail mount. (200mm landing gear and rail mount
sold separately)
Construction
of your air frame is straight forward and easy to understand. There are
no: glues, epoxies or resins; no complicated specialty hardware that is
hard to find and replace, no overly complicated installation of
electronics or searching for a place to mount items. Simple CAD drawings
depict the basic construction of the air frame. CAD diagrams show the
recommended installation of the electronics. American style fasteners
simplify the build using three tools, a 1/16" hex, 5/65" hex and, 5/64
nut driver.
|