Phoenix Flight Gear
XtremeMount
Camera/Accessory Mount
for the
RC EyeONE Xtreme


**GoPro Camera NOT INCLUDED**

**GoPro Camera NOT INCLUDED**

**Mobius Camera NOT INCLUDED**

**Mobius Camera NOT INCLUDED**


Replace the stock
battery tray on your RC EYE One Xtreme and film your flights. This tray
cut from 1mm oriented strand carbon fiber and weighs in at 8 grams with
hardware. The upgrade to your Xtreme will allow you to mount small form
factor cameras such as the GoPro Hero 3 or the Mobius to your Xtreme. If
you are mounting a camera we recommend that you install the Xtreme
Aerial Kit to incase your ground clearance.
The included
adhesive foam strips and velcro strap will allow you to mount multiple
camera types and allows you to adjust the battery to properly balance
for best flight. When flying with the GoPro mounted we recommend that
you use a small wedge of the thin foam between the front edge camera and
frame to angle the camera slightly downward to remove the propellers
from view. If using the Mobius camera we found that using no foam and
having the camera resting on the front LED mount (led removed) tipped
the camera down enough to remove the propellers from view, if you want
vibration dampening then the thick foam and a small piece of thin foam
on the front will also remove the propellers from view.
Also available is the Phoenix Flight Gear Xtreme
CarbonSpyder FPV Micro Frame. A 2mm 3k twill weave solid carbon fiber
frame kit will upgrade the stock frame or replace a broken frame. The
frame relocates the arms to a spyder style frame to get props out of
camera view.
If you are mounting a
GoPro to your Xtreme, you will need additional ground clearance. Until
the RcLogger Xtreme Landing Legs (79mm) are available we recommend that
you install a standoff onto the bottom of each leg with a screw. This
leg extension kit can be purchased here and includes 4 30mm aluminum
standoffs and 4 M3x6 aluminum screws. Install simply by drilling a 1/8"
hole in the bottom of each leg and installing the standoff and screw.
Included:
Carbon fiber battery accessory tray
1 - Thin Foam Strip
1 - Thick Foam strip
4 - M2x20 screws
4 - M2 locknuts
4 - M2 washers
4 - O-rings
1 - Velcro strap
Specs:
Weight with hardware: 7.8g
Approximate size: 110x35, front camera tab 55mm wide
Stock battery tray weight: 3.5g
**Note**
If you are mounting a GoPro to your Xtreme, you
will need additional ground clearance. Until the RcLogger Xtreme
Landing Legs (79mm) are available we recommend that you install a
standoff onto the bottom of each leg with a screw. This leg extension
kit can be purchased here and includes 4 30mm aluminum standoffs and 4
M3x6 aluminum screws. Install simply by drilling a 1/8" hole in the
bottom of each leg and installing the standoff and screw.

Manufactured by Phoenix Flight Gear
"Created and manufactured by pilots for pilots"